BDA
It was suggested during the TS tables that I get in touch with the Brick Development Association. Said and done: on Tuesday 14 April at 11am, I presented to director Michael Driver and engineer Ali Arasteh the TS book together with the first 3d printed corner:
They were both quite excited, and had good advice on how to make a part of this corner come alive at a 1:1 scale (use red rubber bricks, make sure that the larger units are divided into blocks of about 12-13 bricks/25kg, and so on). The next step, we agreed, would be to draw up the detail that is to be constructed as a set of measured drawings that we can actually present to some brick manufacturers.
They were both quite excited, and had good advice on how to make a part of this corner come alive at a 1:1 scale (use red rubber bricks, make sure that the larger units are divided into blocks of about 12-13 bricks/25kg, and so on). The next step, we agreed, would be to draw up the detail that is to be constructed as a set of measured drawings that we can actually present to some brick manufacturers.
Leave a comment