This page contains a single entry by Jasem Alsadah published on February 26, 2008 8:20 PM.
WIP-Plan Plate was the previous entry in this blog.
TS is the next entry in this blog.
Find recent content on the main index or look in the archives to find all content.
MUCH BETTER - column plans look v good!!
YOU MIGHT WANT TO SPREAD THE COLUMNS OUT A BIT ON THE PAGE (IN THE MIDDLE) TO ALLOW FOR THE CENTER FOLD - REMEMBER THE BINDING WILL EAT 1CM of the center of your pages - so is better to redesign now rather than wait for later. n
you should take 2 of the columns (1 per page) - the most complex and most simple of the double twist and show the 4 (or 5?) plans per column with dimensions - how deep are the steel plates, what is the max radius at each stage of the column? how thick is the material? where is it welded? what + where are the joints?